Mr. Sun Fabric Busting Baby Teething Toy Sewing Tutorial

This post and the photos within it may contain Amazon or other affiliate links. If you purchase something through the link, I may receive a small commission at no extra charge to you.

Mr Sun Fabric Buster Baby Teething Toy Tutorial from Sew Creative BlogOne of my dearest friends, Dee, gave birth to a baby boy in December. This baby was very much wished for, for a long time. Dee and I went through similar journeys to bring our sons into this world.

Over the course of trying to conceive our sons we shared long talks over glasses of wine with tears streaming down our cheeks.

We shared big hugs where we fiercely whispered to each other “I know this is going to happen for you. I have faith!” 

We shared text messages of hope, fear, anguish, excitement and then pure bliss as we looked into the eyes of our baby boys. 

Dee and I both feel incredible connections to our own sons as well as each other’s boys. That’s why when I was invited to a baby shower to celebrate the birth of Dee’s baby boy this past weekend I knew that I wanted to make him an extra special handmade gift in addition to a book for his library. 

I decided to make Dee’s baby boy a Mr. Sun teething toy, because I know how much this little boy has brightened his mama’s life (along with the life of his Daddy and big sister!) I thought that Mr. Sun made such a sweet baby teething toy that I would share it with you in case you want to make one for your own baby or as a shower gift. 

Mr Sun Fabric Scrap Busting Baby Teething Toy Tutorial from Sew Creative BlogMr Sun Fabric Busting Baby Teething Toy Sewing Tutorial 

Materials Needed:

  • Yellow Fleece for body of sun
  • Scraps of brightly colored fabric for the rays of the sun
  • Red felt for the cheeks and mouth of the sun
  • Eyes for the sun (I used blue snaps and applied them with my snap press so that they aren’t going anywhere. You want to make sure to use something that is impossible for the baby to pull off. Felt for the eyes would be a good alternative.)
  • Cotton batting to fill the sun with
  • Coordinating thread
  • Needle
  • Scissors
  • Sewing Machine
  • Iron

Directions:

Mr Sun Fabric Buster Baby Toy Tutorial step 1.jpgStep 1: Figure out how big you want your sun to be. I chose a plate to trace for my circle. Trace two circles on your yellow felt

Mr Sun Fabric Buster Baby Toy Tutorial step 2Step 2: Cut out your fabric circles leaving approximately a 1/2 inch border between the circle that you traced and where you are cutting. 

Mr Sun Fabric Buster Baby Toy Tutorial step 3Step 3: Cut out a mouth and circles for the cheeks from red felt. (If you are making felt eyes do them at this point too). I put pins into the fabric where my traced circle was on the back of the fabric so that I could properly center the sun’s face. Sew on the cheeks and mouth and attach the eyes. 

Mr Sun Fabric Buster Baby Toy Tutorial step 4Step 4:  On a piece of paper draw a sun ray to use as a template. Make sure that your ray is a bit wider and longer than how you will want it to allow for a seam allowance. Cut the rays out of your fabric scraps. Place the rays so that the fabric is right side together. Using a 1/4 inch seam allowance sew up one side of the ray, around the rounded part and down the other side. Do not sew the bottom of the ray. Turn rays right side out and press with an iron. For my project I used 13 rays. You can use more or less depending on the size of your sun, how big your rays are and how close or far away you want each ray from each other. 

Mr Sun Fabric Buster Baby Toy Tutorial step 5Step 5: Evenly space the rays around the perimeter of the sun and pin into place. This should be done on the side of the sun with the face with the rounded edges of the rays pointing towards the center of the sun (as pictured above). 

Mr Sun Fabric Buster Baby Toy Tutorial step 6Step 6: Using your sewing machine baste the rays into place roughly half way between the edge of your fabric and where the circle that you drew on the back of your fabric is. 

Mr Sun Fabric Buster Baby Toy Tutorial step 7Step 7: Place your second felt circle on top of your circle with the rays attached, sandwiching the rays and the face in the middle. Pin into place and sew around your traced circle leaving a 2 inch opening so that you can turn your sun right side out. Backstitch at the beginning and end of your sewing.  

Mr Sun Fabric Buster Baby Toy Tutorial step 8Step 8: You will be left with something that looks like this. Trim your threads, remove your pins and flip your sun right side out.  The easies way to do this is to pull one of the sun’s rays through the gap that you left open and gently pull it through to the outside. 

Mr Sun Fabric Buster Baby Toy Tutorial step 9Step 9: Fill your sun with cotton batting and hand sew the opening closed using coordinating thread. Iron the rays of the sun if needed. 

I hope that you enjoyed our Mr. Sun Fabric Busting Baby Teething Toy Sewing Tutorial. If you are looking for another fabulous handmade baby gift check out our 15 Minute Baby Bib Sewing Tutorial.

Sew-Creatives-15-Minute-Baby-Bib-Sewing-Tutorial-1-853x1024

Like what you see on Sew Creative? Commenting on our posts, pinning our recipes and craft projects, following us on PinterestTwitterFacebook and subscribing (in the box in the side bar towards the top in the right hand column) mean a lot to us. 

Tell me… Do you have a “Go To Gift” for baby showers? What is the favorite baby gift that you ever gave (or received)? Do you like to give handmade gifts? If you’ve ever given a handmade baby gift we’d love to hear about it!

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

10 Comments

  1. I have some plastic tongue depressors. These could be cut in half with a hack saw, and put into the rays to give them more “bite”. Wood ones probably wouldn’t be safe because they crack and splinter.

    1. Hi Paula,

      That sounds like an interesting idea! I never would have thought of it. 🙂 I considered filling each ray with cotton batting but in the end kind of liked them being floppy. 🙂

      Thank you for visiting!

      Best Wishes,

      Crystal

    1. Thank you so much Virginia. It was definitely a big hit and got lots of attention as it was passed around the room after she opened it. 🙂

      Thank you for visiting!

      Best Wishes,

      Crystal

  2. I love baby toys. These would make great baby shower gifts, and your tutorial makes it look easy to do. Thanks for sharing!!

    1. Thank you so much Michelle! It was a pretty fun project to make. It could have so many different looks depending on what fabric scraps you use. If you make one I’d love to see it.

      Thank you for visiting!

      Best Wishes,

      Crystal

  3. Wow ,Crystal, what a name “Mr Sun Fabric Busting Baby Teething Toy”. Colors are amazing and looks like a fun project to do. Tfs!

  4. This is a great idea! We can make easily and these colorful fabrics are attracting kids.

  5. It is a perfect gift for a new born child, I think. I found it easy and quick to make. It is so kind making a present for someone who doesn’t even have a concept of presents, haha.